Repeat steps 4-7 for any remaining devices in the Universal Serial Bus Controllers section with “ Root Hub” in the name.

Clear the box next to Allow the computer to turn off this device to save power.

Right-click the first USB Root Hub device and select Properties.

Expand Universal Serial Bus controllers by clicking the arrow to the left of it.

On your desktop, right-click the My Computer icon and select Properties.

Click the Start button and select Control Panel.

Note: You may need to disconnect and re-connect your USB device after applying these settings to re-establish the connection.

Click the plus sign (+) next to “USB settings” and “USB selective suspend setting” to expand the options and change the setting to Disabled.

Click Change plan settings for the plan you want to change.

Click Hardware and Sound, then click Power Options.

The USB 2.0 to IDE Drive Adapter turns any IDE drive into a convenient external drive.

On your keyboard, press the Windows key + X and select Control Panel. The USB 2.0 to IDE Drive Adapter implements a bridge between one USB port and one ATA or ATAPI based mass storage device port.

The steps below outline how to configure the USB root hub to stay on during hibernation, to prevent this from happening. If the USB device does not work after your computer has been in extended hibernation, it is likely that Windows has automatically turned off the USB Root hub to save power. For more information, refer to the documentation provided by the manufacturer. On other drives, there are markings on the circuit board for CS, MA, and SL, which means a jumper shorts the pins vertically in that position. On some drives, the jumper diagram is on the label that is on the top of the drive. There is no standard position for the jumpers on IDE drives. If you need connect 3.5 IDE HDD, please reference as below : Step 1: Please plug USB TO IDE&SATA CABLEL connect to HDDHDD should connect power adapter. If Master is not working, try using the drive in Cable Select. When it does not mention what IDE drive configuration is required or if there is only one drive in the setup, the drive should be configured as Master. A jumper is a small plastic piece that slides on top of two pins to electrically short them together. The jumpers switch the drive between Master, Slave, and Cable Select for most drives. If you are unable to detect your IDE (PATA) drive using a product, you may need to change the jumper settings on your drive. Note: If you are using an IDE hard drive 1 Gigabyte in size or smaller, refer to the following FAQ: Universal power adapter (NA/JP, UK, EU, AU) B marked units tested with 6TB 4Kn 7200 RPM drive in Mac OS 10.12 and Windows 10 OS independent No software or drivers requiredīackwards compatible with USB 1.1 standard, but not recommended due to slow transfer rate.

Bytecc usb to ide